RTC Calibration?
Posted: Thu Oct 15, 2020 12:31 am
Hi all,
Just a question to improve clock accuracy on Voyager calculators... if the hardware allows it!
Would it be possible to change the firmware so it accepts a "RTC Calibration" value?
The value could be pushed thru a Serial Console command (after calculation) and/or a combination of [Key]+[On] for +1 unit or -1 unit of the "RTC Calibration" value...
Sincerely,
Boubker.
Just a question to improve clock accuracy on Voyager calculators... if the hardware allows it!
Would it be possible to change the firmware so it accepts a "RTC Calibration" value?
The value could be pushed thru a Serial Console command (after calculation) and/or a combination of [Key]+[On] for +1 unit or -1 unit of the "RTC Calibration" value...
Sincerely,
Boubker.