Casing not snug in the centre

Forum for discussion of the DM10, DM11, DM12, DM15, DM16 and DM41 units
Post Reply
Zaphod
Posts: 24
Joined: Sat Mar 31, 2018 11:34 pm

Casing not snug in the centre

Post by Zaphod » Wed Apr 18, 2018 12:44 am

Just got my DM15 on Monday and I noticed on the front edge, where the top case meets the bottom section there is a small gap, only in the central area....perhaps 0.5mm
I can press the top frame down gently and close the gap fully, but it obviously springs back up afterwards

Presumably because of the lack of a screw here ..... or an internal central latch/catch

Anyone else ? .... or have I got a one-off ?

gmac42
Posts: 42
Joined: Fri Jun 01, 2018 11:30 am

Re: Casing not snug in the centre

Post by gmac42 » Tue Jun 05, 2018 1:20 pm

My DM41L has that too, but only very slightly. It gets worse if you overtighten the mainboard screws a bit.
Definitely not 0.5 mm though, maybe 0.2 at most, in my case, so I don't mind.
DM42 #650, DM41L #801, HP 41CX, HP 41CV, HP 50G, TI 89

Post Reply