Stopwatch Jumps

Please report issues with the DM41X Beta Firmware in this sub-forum
Post Reply
Posts: 5
Joined: Wed May 30, 2018 12:49 pm
Location: Austria

Stopwatch Jumps

Post by FireBird »

The stopwatch function on my DM41X behaves a bit weird as from time to time it adds about 30 hours and 29 minutes to the current elapsed time. From time to time means that I’ve seen this happening 2 minutes after starting the watch and sometimes it took more than 30 minutes to happen. The offset gets added, I had 90+ hours shown at some point.

Started from memory lost state, no other modules are loaded. Here’s a short demo video.

Can someone confirm this?

DMCP v3.18t02
DM41X V1.11t02
Clock correction: -19,1ppm

Posts: 1029
Joined: Mon Apr 24, 2017 7:48 pm
Location: New York

Re: Stopwatch Jumps

Post by rprosperi »


In my case, there is no clock correction factor applied, and I have several modules and programs installed, but the basic bug did occur, sometime in the first 15 minutes. It seems to have added 30 hours and about 27 minutes (vs. 29) but I wasn't timing (or even watching) closely so my numbers are sloppy. I'll report it and thanks for noticing, the report and video!
--bob p

DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100
User avatar
Posts: 548
Joined: Tue May 02, 2017 1:56 pm
Location: Milan, Italy

Re: Stopwatch Jumps

Post by akaTB »

Possibly connected to this?
-+×÷ left is right and right is wrong :twisted: Casted in gold
Post Reply