Key overlay - MS Word version
Posted: Thu Oct 22, 2020 10:22 pm
I made a key overlay utillizing the "table" function in MS Word . The word file is attached (*.docx format). You may use/adapt it for your own needs.
This is the procedure:
1. Print out on standard copy paper (80grs/sqm). Alter key names before, if and as required.
2. Laminate with 80 mics stock (result is a thickness of about 0,25 mm).
2. Cut out voids for keys and perimeter. Attention: Tabs as shown are too wide and too long, cut smaller.
Regards,
Werner
- DM41X_standard_overlay_installed.jpg (162.47 KiB) Viewed 471 times
1. Print out on standard copy paper (80grs/sqm). Alter key names before, if and as required.
2. Laminate with 80 mics stock (result is a thickness of about 0,25 mm).
2. Cut out voids for keys and perimeter. Attention: Tabs as shown are too wide and too long, cut smaller.
Regards,
Werner