I made a key overlay utillizing the "table" function in MS Word . The word file is attached (*.docx format). You may use/adapt it for your own needs.
1. Print out on standard copy paper (80grs/sqm). Alter key names before, if and as required.
2. Laminate with 80 mics stock (result is a thickness of about 0,25 mm).
2. Cut out voids for keys and perimeter. Attention: Tabs as shown are too wide and too long, cut smaller.
Regards,
Werner
This is the procedure:Key overlay - MS Word version
Key overlay - MS Word version
- Attachments
-
- DM41X_Standard_Keyboard_Overlay.docx
- (20.12 KiB) Downloaded 230 times
Re: Key overlay - MS Word version
Thank you. I really appreciate this. Be well.
DM42 (#6476), DM41X (#458), DM15, 12 - HP 12, 17BII, 35(2), 45, HP 27S, 28S, 30B, 41CV, 41CX, 42S, 48S, 35S, HP10bII+, 12C PLAT
I may have a problem!
I may have a problem!
Re: Key overlay - MS Word version
Here's a draft modification of that file for the Sandmath module. If anyone can take this and run with it...
It is not complete!
Gene
It is not complete!
Gene
- Attachments
-
- DM41X_SandMath_Keyboard_Overlay_DRAFT.docx
- (21.23 KiB) Downloaded 204 times
Re: Key overlay - MS Word version
Updated... much more complete for Sandmath.
- Attachments
-
- DM41X_SandMath_Keyboard_Overlay_V2.docx
- (22.64 KiB) Downloaded 212 times