I have DM41X Beta SN:00040.
Today I was changing my active module configuration and got a blank screen after pressing ENTER.
The Calculator would not respond to keystrokes at this point. I pressed the reset button and got no response.
I removed and replaced the battery and it seemed to boot up. After pressing ON to continue and setting the time and date I got the following screen:
Again, the Calculator would not respond to keystrokes.
Not being able to get into USB Mode, I used dfu-util to re-flash the firmware.
I got all the correct responses from dfu-util as shown in the manual but now I get this:
with no response from the keyboard or the reset button.
I have killed my DM41X
- Dan Simpson
- Posts: 105
- Joined: Wed Mar 18, 2020 3:29 pm
- Location: Arizona
I have killed my DM41X
My Collection: HP-55, HP-67 (Teenix Mod), HP-15C, HP-16C, HP-41CV, HP-41CX, SY41-CL, DM41X, DM42, HP-42S, HP-48G, HP-71B, HP-75C, HP-86B.
Re: I have killed my DM41X
There is a 2nd button on the board, near the reset button but not accessible from the outside (i.e. you must open the case) which should put the device back into f/w update mode. Connect the cable and get the update s/w ready, then press this 2nd button and start the update, it should proceed and complete the update. And even though you're connected via USB, I'd insert a new battery if available.
--bob p
DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100
DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100
- Dan Simpson
- Posts: 105
- Joined: Wed Mar 18, 2020 3:29 pm
- Location: Arizona
Re: I have killed my DM41X
I did use the second button to get into bootloader mode. That is how I was able to use dfu-util to re-flash the firmware. I tried it with and without a battery installed. Both times dfu-util indicated a successful flash but with the same result. But I think i see a problem.
In the manual,
Code: Select all
Downloading to address = 0x08000000, size = 756288
Code: Select all
Downloading element to address = 0x08000000, size = 287
My Collection: HP-55, HP-67 (Teenix Mod), HP-15C, HP-16C, HP-41CV, HP-41CX, SY41-CL, DM41X, DM42, HP-42S, HP-48G, HP-71B, HP-75C, HP-86B.
Re: I have killed my DM41X
Ah, good news then!
Thanks for confirming the solution and glad all is well.
Thanks for confirming the solution and glad all is well.
--bob p
DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100
DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100