Hello all!
I tried to make a 3D printable keyboard stencil for the DM42 (and probably DM41X too).
See:
https://www.thingiverse.com/thing:4917437/files
I think the old HP41 had something like that to "handwrite" some key functions on it.
To be honest: I don't see much use in it so far - do you have any ideas how to use or redesign it for more sense?
Regards
deetee
DM42 (DM41X) 3D Printable Keyboard Stencil
Re: DM42 (DM41X) 3D Printable Keyboard Stencil
If you want your stencil becoming an overlay then don't forget the six tabs (a.k.a. tongues). Such an overlay should not be thicker than 0.3mm.
WP43 SN00000, 34S, and 31S for obvious reasons; HP-35, 45, ..., 35S, 15CE, DM16L S/N# 00093, DM42β SN:00041
Re: DM42 (DM41X) 3D Printable Keyboard Stencil
Has anyone printed one of these? Report, how did it work and fit. For years I used the Structural PAC, the overlay is essential, IMO. Using that PAC on DM41X requires a cheat sheet.
Cheers - Bill Fleming