UPDATE: DMCP-3.13 / DM42-3.13

This is where announcements of official firmware updates provided by SwissMicros for the DM42 calculator will be made.

Please do not post bug reports here. The Usage tips, tricks and problem reports forum is there for that.

Please do not post notices of third party firmware builds here, they will be deleted. Instead, please use the Third Party firmware builds forum for this purpose.
HPMike
Posts: 439
Joined: Fri Jul 21, 2017 11:01 pm
Location: DFW, Texas

Re: UPDATE: DMCP-3.13 / DM42-3.13

Post by HPMike »

d4days wrote:
Tue May 21, 2019 1:52 pm
HPMike wrote:
Tue May 14, 2019 4:22 am
d4days wrote:
Sat May 11, 2019 3:55 am
I installed the 3.13 update and it seems to work fine. However, it seems to reset itself after not using it for an hour or so. And, the settings reset. Not sure what's going on.
During the install did you keep your calculator connected to the computer USB port to avoid drain on the battery ? The flash process drains the battery quite a bit, and your battery may be low.
I did keep the calculator connected. It's at 2.78v according to the status bar.
OK, that voltage level seems high enough not to cause resets. Unless someone else has a better idea, why don't you just try downloading the file again and then reflash the firmware.
DM15L, S/N 00548. DM42, SN: 00159. DM41X, SN: 00973. DM32, SN 00054.
Post Reply