Page 3 of 3

Re: UPDATE: DMCP-3.9a / DM42-3.9.1 / dm_tool-2.4

Posted: Mon Sep 03, 2018 12:42 pm
by H2X
sadsilence wrote:
Tue Aug 28, 2018 9:33 pm
zeno333 wrote:
Tue Aug 28, 2018 4:53 am
I have Firmware version 3.5...Would the #3 combined Binary work with that version via the FAT USB drive update option?...(I presume one still uses the option "Flash Firmware from USB even with the combined file...)
Did exactly that last week. Worked perfectly.
Me too (last week in my case being the last week of August 2018). The update apparently went fine, but yesterday it behaved rather oddly when I switched it on - the screen was rendered only partially.

Switching off and on again seemed to cure it, for now at least...

Re: UPDATE: DMCP-3.9a / DM42-3.9.1 / dm_tool-2.4

Posted: Mon Sep 03, 2018 9:31 pm
by sadsilence
Still no problems here.
H2X wrote:
Mon Sep 03, 2018 12:42 pm
sadsilence wrote:
Tue Aug 28, 2018 9:33 pm
zeno333 wrote:
Tue Aug 28, 2018 4:53 am
I have Firmware version 3.5...Would the #3 combined Binary work with that version via the FAT USB drive update option?...(I presume one still uses the option "Flash Firmware from USB even with the combined file...)
Did exactly that last week. Worked perfectly.
Me too (last week in my case being the last week of August 2018). The update apparently went fine, but yesterday it behaved rather oddly when I switched it on - the screen was rendered only partially.

Switching off and on again seemed to cure it, for now at least...