DM42 Firmware V3.4 available

This is where announcements of official firmware updates provided by SwissMicros for the DM42 calculator will be made.

Please do not post bug reports here. The Usage tips, tricks and problem reports forum is there for that.

Please do not post notices of third party firmware builds here, they will be deleted. Instead, please use the Third Party firmware builds forum for this purpose.
DA74254
Posts: 192
Joined: Tue Oct 03, 2017 11:20 pm
Location: Norway/Latvia

Re: DM42 Firmware V3.4 available

Post by DA74254 »

Thanks to David, Michael, Thomas and grsbanks for making all this happen.

I've just done my very first update, from the "stock" 3.0 to 3.4a. Mostly I've been reluctant due to the very quarrelsome win10 and "unsigned drivers" and also, I've had other priorities when at home from work (seaman).
Anyway, I have an older Samsung Netbook from the pre-tab-era which is running the only reasonable win version, namely the 7. It's normally used in conjunction with my 3D-printer (which I've slightly FW-hacked, and therefore refuses to speak with win10) and used that for installing the necessary tools and drivers.
Aaand yes - it went smoothly and very straight-forward.

Also, the HP50G ant the Conn4x will be run on my "legacy" NetBook :)
Esben
DM42 SN: 00245, WP43 Pilot SN:00002, DM32 SN: 00045 (Listed in obtained order).
Post Reply