Extended functions in menu

Discussion around the SwissMicros DM42 calculator
Post Reply
Edaxx
Posts: 2
Joined: Thu Mar 11, 2021 12:58 pm

Extended functions in menu

Post by Edaxx »

It was only after executing an extended function through alpha naming (e.g. XEQ ALPHA "DDAYS") that all the extended function appeared at the end of the [CATALOG][FCN] menu; before that they were not there.

Of course it is possible that I did something that effectively switched this off, but can't figure out what...
34C -> 11C/15C -> 42S -> DM42/DM41X
Post Reply