Firmware V31 for DM1x/DM41(L) units

Firmware updates will be announced in this forum. The forum is marked as read-only, so if you have a problem with a new version then please report it in either the "DM1x/DM41 Usage tips, tricks and questions" forum or if you think it is a bug, then in the "DM1x/DM41 Bug reports" forum.
dylanmitchell
Posts: 7
Joined: Fri Jul 02, 2021 7:01 am

Re: Firmware V31 for DM1x/DM41(L) units

Post by dylanmitchell »

My DM12L arrived with VM 28 installed. I updated to DM12_31.hex 2020-07-21 after figuring out a few differences in the process. For the DM12L I used ON + PV to access the serial console and the PRGRM button when it said reset. PV + ON showed VM 31 installed and the self-test ran fine. Installed with Windows 10.
User avatar
dalremnei
Posts: 43
Joined: Thu Dec 10, 2020 11:32 am
Location: Scotland

Re: Firmware V31 for DM1x/DM41(L) units

Post by dalremnei »

I have been unable to update my device. When I try to follow the instructions in the voyager updater software, I just get the following error:

Code: Select all

Warning:  data not aligned to 32 bits, padded (length was 89C3, now 89C4)
Can't open COM-Port \\.\COM3 ! - Error: 5
How do I fix this?
SwissMicros DM42, DM16L, HP 12c Platinum, Prime G2 CASIO fx-9750gii, fx-991ex classwiz, fx-CG50, TEXET fx1500, TI nspire CX II-T
ctrclckws
Posts: 173
Joined: Sun Feb 17, 2019 4:30 pm

Re: Firmware V31 for DM1x/DM41(L) units

Post by ctrclckws »

On the installer software, you may need to change the com port number.
DM10, DM10L: 00031 / DM11, DM11L: 00112 / DM12, DM12L: 02074
DM15, DM15L: 11069 / DM16. DM16L: 02001 / DM41, DM41L: 00859
DM41X: 00036ß / 00181 DM42: 3108 / 6084 WP43: 0032
User avatar
dalremnei
Posts: 43
Joined: Thu Dec 10, 2020 11:32 am
Location: Scotland

Re: Firmware V31 for DM1x/DM41(L) units

Post by dalremnei »

It's the correct port number though.
SwissMicros DM42, DM16L, HP 12c Platinum, Prime G2 CASIO fx-9750gii, fx-991ex classwiz, fx-CG50, TEXET fx1500, TI nspire CX II-T
Post Reply