SwissMicros Calculator Forum

Hallo together,
since I have the DM41L (about two months) it has happened a few times(may be 5 times), that I had problems to turn the calculator on. I had to press the "ON"-key 4-5 times until the calculator switched on. After it had switched on, the time of the clock had changed (today it was about 30 minutes wrong, although the time was correct before).
Normally the "ON"-key works without problems, so I think this issue is also somehow related to the time-function of the calculator.
Anyone has an idea, where the problem comes from and/or what I should try to do?
Thank you,
Stefan

Not the same issue, but mine randomly switched off automatically, and reset itself. Michael sent me a new main board. Now everything is working as it should (though I use the L a lot less, now I have the X).

Update:
Meanwhile I have made a reset of the calculator (by pressing CLX and ON) and obviously the bug has disappeared. If it comes again I will let you know.
Stefan

Update:
The bug has appeared again. It has to do with the commands SETIME or SETAF. After using these commands (I have to look which one of the two) the problem always appears.
Any suggestions?

Update:
It is the command SETAF resp. CORRECT that causes the bug.
When I dont`t use these commands the bug does not appear.