SwissMicros Calculator Forum

@ Dani

Do you know what the material is... very curious!

The nice thing too about a polymer like that is its capacity for just the right amount of flex for easy installation ... while being stiff enough to not have a cheap feel and rattle or flop around while inserted. VERY easy to process and machine as well .....

I'm thinking the one on the left (maybe the right as well) is Acetal ... or perhaps you already know what it is? Judging from the phto I put it somewhere in the vicinity of 0.022" - 0.030" thick.

I think you may not have gone through the 6 pages of the pdf document.

Yes. him. Page 40 of this forum. It is actually UV Cured inkjet printed on a suitable substrate and then laser cut. It could be removable or adhesive backed. It shouldn't be too permanent so it can be replaced when the WP44C comes out... What kind of material can be used? What suitable material is ...

Two Weims ...? I think it was on the laser printing. Must have missed the template sent by Dani ... where can it be viewed? Thanks Yes. him. Page 40 of this forum. It is actually UV Cured inkjet printed on a suitable substrate and then laser cut. It could be removable or adhesive backed. It shouldn...

Two Weims ...? I think it was on the laser printing.

Must have missed the template sent by Dani ...
where can it be viewed? Thanks

To give you a better impression of how an overlay might look like, I have attached three pictures. First the DM42 and the Text Editor overlay for the DM-41. Then the two crops in the same scale from the DM-41 Text Editor overlay and from the DM42. I dusted off my old TI 58C. I understand overlays t...

Which renderings ... versions, configurations ... would yo like for Saturday.

Either way, whether I acquire some new software or not, I should be able to put together a small varied collection of further refined renderings suitable for review for the first of next week. (You mentioned you have a trip ... so then perhaps first of the week will be good for you ...?) In the mean...