www.SwissMicros.com

I have some code that simply steps through (all 100) REG memories; recalling the memory location (in Y) and memory contents (in X). This is a simple loop, terminated in ISG of the counter and jumps back to the recall and Pause (PSE) loop. IF RefLCD is set to 0, the code stops before the PSE. I do un...

Put me in for one too!

TomC

Geoff:

Awwww....tnx for the special attention!!!

I'm not sure when/if this was announced, but I stumbled into it! Makes the code much simpler/less cumbersome/does not 'waste' any memories!

TomC

Perhaps I've missed details of an update, but I can access GrMod and RefLCD WITHOUT using indirection. I first did this accidentally, but then verified it! The current .pdf file [3.14]still shows indirection is required, yet the help file [2018-08-31] on the DM42 does not mention the indirection req...

I would like to formally request that the alarm functionality(ies) be added to the DM42.

This functionality was in the 41, and this would make the DM42 a more worthy successor to the 41!

Thank you,
TomC
ps: Thanks again for the DM42 - a great machine!

Thanks for the reply.

Is there a hardware limitation?

TomC

Hello:

Apologies if this has been covered already.

Can the DM42 be used as an alarm clock - ie waking me at 530am every weekday morning?

(I use my HP48 quite regularly for this and was hoping the DM42 is able to !)

TIA
TomC

Thomas:

Thank you for the prompt informative reply. I will have to test these different modes.

Regards,

I have noticed that the justification (right vs left) is dependent of the state the printer was left in. I have successive printouts on the same 'tape' whereby the last pgm printout is properly left justified. I suspect there is an issue with the state the print buffer in the 82240 is left after a P...

PRLCD seems to have two issues: 1. Does not print the entire LCD. I'm using it from the print menu while in Calc mode. 2. It does not print the bottow line of the LCD until the next print command. It also does not 'do a CR' - the next print command starts at the end of the end of the PRLCD output. P...