There's a phenomenon on the DM41/L where, when in 12 MHz mode, the screen exhibits strange behavior when running something like the stopwatch. The best I can describe it is like tearing or flickering. This behavior isn't present when running in 48 MHz mode, and so I wonder if the 12 MHz mode is not fast enough to replicate the original calculator's speed or if there's some bug. (Presumably the 48 MHz mode causes the DM41 to run much faster than the HP-41.)
I notice this behavior on each of my two DM41 units and my DM41L. I noticed it on firmware v22 and after updating to v25 (these are the only two firmware versions I have run on the DMx series calculators).
[DM41] Screen tearing
Re: [DM41] Screen tearing
Were you running a program at the time, or was the calculator just sitting there?reavy wrote: ↑Thu Feb 08, 2018 5:01 amThere's a phenomenon on the DM41/L where, when in 12 MHz mode, the screen exhibits strange behavior when running something like the stopwatch. The best I can describe it is like tearing or flickering. This behavior isn't present when running in 48 MHz mode, and so I wonder if the 12 MHz mode is not fast enough to replicate the original calculator's speed or if there's some bug. (Presumably the 48 MHz mode causes the DM41 to run much faster than the HP-41.)
I notice this behavior on each of my two DM41 units and my DM41L. I noticed it on firmware v22 and after updating to v25 (these are the only two firmware versions I have run on the DMx series calculators).
If running a program, you may want to post it here, so others can attempt to duplicate this.
DM42 SN: 0612
Re: [DM41] Screen tearing
It’s only when running a program. The stopwatch function on the DM41 is the easiest way to reproduce it.
I will consider making a video of the phenomenon within the next few days and including a link here.
I will consider making a video of the phenomenon within the next few days and including a link here.
Re: [DM41] Screen tearing
Hi
Is it the same as point 1) I describe here : viewtopic.php?f=10&t=311
Is it the same as point 1) I describe here : viewtopic.php?f=10&t=311
Sincèrement, Sincerely, 73,
Boubker
DM15L, DM41L, DM42 #00855 (domes upgraded), DM41X #00707
HP48SX (with dark screen), HP42s, HP32SII (1990 with fraction bug), HP41C/CV
TI-89 titanium, CASIO fx-cg50 and Numworks (to play with micropython)
Boubker
DM15L, DM41L, DM42 #00855 (domes upgraded), DM41X #00707
HP48SX (with dark screen), HP42s, HP32SII (1990 with fraction bug), HP41C/CV
TI-89 titanium, CASIO fx-cg50 and Numworks (to play with micropython)
Re: [DM41] Screen tearing
It does sound similar, but I believe I observed the effect on the DM15L, too.
Does the effect go away for you when setting the speed to 48 MHz?
Does the effect go away for you when setting the speed to 48 MHz?