Page 1 of 1

Casing not snug in the centre

Posted: Wed Apr 18, 2018 12:44 am
by Zaphod
Just got my DM15 on Monday and I noticed on the front edge, where the top case meets the bottom section there is a small gap, only in the central area....perhaps 0.5mm
I can press the top frame down gently and close the gap fully, but it obviously springs back up afterwards

Presumably because of the lack of a screw here ..... or an internal central latch/catch

Anyone else ? .... or have I got a one-off ?

Re: Casing not snug in the centre

Posted: Tue Jun 05, 2018 1:20 pm
by gmac42
My DM41L has that too, but only very slightly. It gets worse if you overtighten the mainboard screws a bit.
Definitely not 0.5 mm though, maybe 0.2 at most, in my case, so I don't mind.