Just got my DM15 on Monday and I noticed on the front edge, where the top case meets the bottom section there is a small gap, only in the central area....perhaps 0.5mm
I can press the top frame down gently and close the gap fully, but it obviously springs back up afterwards
Presumably because of the lack of a screw here ..... or an internal central latch/catch
Anyone else ? .... or have I got a one-off ?
Casing not snug in the centre
Re: Casing not snug in the centre
My DM41L has that too, but only very slightly. It gets worse if you overtighten the mainboard screws a bit.
Definitely not 0.5 mm though, maybe 0.2 at most, in my case, so I don't mind.
Definitely not 0.5 mm though, maybe 0.2 at most, in my case, so I don't mind.
DM41X #542, DM42 #650, DM41L #801, HP 41CX, HP 41CV, HP 50G, HP11C, TI 89