Casing not snug in the centre

Forum for discussion of the DM10, DM11, DM12, DM15, DM16 and DM41 units
Post Reply
Zaphod
Posts: 22
Joined: Sat Mar 31, 2018 9:34 pm

Casing not snug in the centre

Post by Zaphod » Tue Apr 17, 2018 10:44 pm

Just got my DM15 on Monday and I noticed on the front edge, where the top case meets the bottom section there is a small gap, only in the central area....perhaps 0.5mm
I can press the top frame down gently and close the gap fully, but it obviously springs back up afterwards

Presumably because of the lack of a screw here ..... or an internal central latch/catch

Anyone else ? .... or have I got a one-off ?

Post Reply