ERROR in line sync 6

Post here to share useful tips and tricks, to ask questions about using your DM42 or to report software-related problems
Post Reply
User avatar
Stefan Karlsson
Posts: 26
Joined: Thu Apr 04, 2019 10:26 pm

ERROR in line sync 6

Post by Stefan Karlsson »

The following procedure consistently makes my DM42 display the message "ERROR in line sync 6":
  • Press F1 (the help document is opened in the browser).
  • Press F2 (the browser jumps to the document's table of contents).
  • Press [+] to move one line forward. Do this about 35 times.
I can still reproduce the above after a RESET+[-].

Also, on the 29th press on [+], the browser does not move forward. On the 30th press it does move forward again.
grsbanks
Posts: 1122
Joined: Tue Apr 25, 2017 11:23 am
Location: Preston, Lancs, UK
Contact:

Re: ERROR in line sync 6

Post by grsbanks »

Confirmed on my unit. I've flagged it up.
There are only 10 kinds of people in the world: those who understand binary and those who do not.
User avatar
Stefan Karlsson
Posts: 26
Joined: Thu Apr 04, 2019 10:26 pm

Re: ERROR in line sync 6

Post by Stefan Karlsson »

Great, thank you.

I noticed that after I'd done the RESET+[-] magic, the machine pretended that the old state was still loaded. For example, it was "selected" in the SETUP menu. Is that intentional?
grsbanks
Posts: 1122
Joined: Tue Apr 25, 2017 11:23 am
Location: Preston, Lancs, UK
Contact:

Re: ERROR in line sync 6

Post by grsbanks »

Yes, that is normal. You can, however, go into the settings and start with a clean machine state.
There are only 10 kinds of people in the world: those who understand binary and those who do not.
Post Reply