Re: DM42 Firmware V3.4 available
Posted: Thu Mar 22, 2018 10:35 am
Thanks to David, Michael, Thomas and grsbanks for making all this happen.
I've just done my very first update, from the "stock" 3.0 to 3.4a. Mostly I've been reluctant due to the very quarrelsome win10 and "unsigned drivers" and also, I've had other priorities when at home from work (seaman).
Anyway, I have an older Samsung Netbook from the pre-tab-era which is running the only reasonable win version, namely the 7. It's normally used in conjunction with my 3D-printer (which I've slightly FW-hacked, and therefore refuses to speak with win10) and used that for installing the necessary tools and drivers.
Aaand yes - it went smoothly and very straight-forward.
Also, the HP50G ant the Conn4x will be run on my "legacy" NetBook
I've just done my very first update, from the "stock" 3.0 to 3.4a. Mostly I've been reluctant due to the very quarrelsome win10 and "unsigned drivers" and also, I've had other priorities when at home from work (seaman).
Anyway, I have an older Samsung Netbook from the pre-tab-era which is running the only reasonable win version, namely the 7. It's normally used in conjunction with my 3D-printer (which I've slightly FW-hacked, and therefore refuses to speak with win10) and used that for installing the necessary tools and drivers.
Aaand yes - it went smoothly and very straight-forward.
Also, the HP50G ant the Conn4x will be run on my "legacy" NetBook