UPDATE: DMCP-3.9a / DM42-3.9.1 / dm_tool-2.4

This is where announcements of firmware updates for the DM42 calculator will be made
User avatar
H2X
Posts: 252
Joined: Tue Apr 25, 2017 6:00 am
Location: Norway

Re: UPDATE: DMCP-3.9a / DM42-3.9.1 / dm_tool-2.4

Post by H2X » Mon Sep 03, 2018 10:42 am

sadsilence wrote:
Tue Aug 28, 2018 7:33 pm
zeno333 wrote:
Tue Aug 28, 2018 2:53 am
I have Firmware version 3.5...Would the #3 combined Binary work with that version via the FAT USB drive update option?...(I presume one still uses the option "Flash Firmware from USB even with the combined file...)
Did exactly that last week. Worked perfectly.
Me too (last week in my case being the last week of August 2018). The update apparently went fine, but yesterday it behaved rather oddly when I switched it on - the screen was rendered only partially.

Switching off and on again seemed to cure it, for now at least...
DM42 SN:00040
Be enter not or (Hamlet Yoda not)

sadsilence
Posts: 14
Joined: Thu Jun 15, 2017 5:50 am
Location: Germany

Re: UPDATE: DMCP-3.9a / DM42-3.9.1 / dm_tool-2.4

Post by sadsilence » Mon Sep 03, 2018 7:31 pm

Still no problems here.
H2X wrote:
Mon Sep 03, 2018 10:42 am
sadsilence wrote:
Tue Aug 28, 2018 7:33 pm
zeno333 wrote:
Tue Aug 28, 2018 2:53 am
I have Firmware version 3.5...Would the #3 combined Binary work with that version via the FAT USB drive update option?...(I presume one still uses the option "Flash Firmware from USB even with the combined file...)
Did exactly that last week. Worked perfectly.
Me too (last week in my case being the last week of August 2018). The update apparently went fine, but yesterday it behaved rather oddly when I switched it on - the screen was rendered only partially.

Switching off and on again seemed to cure it, for now at least...

Post Reply