What should we do with the new 3.5?

Discussion around the SwissMicros DM42 calculator
Post Reply
zeno333
Posts: 83
Joined: Fri Dec 29, 2017 1:34 am

What should we do with the new 3.5?

Post by zeno333 »

It says..."New DMCP+DM42 combo fw only" What does fw only mean?...There is a new combo file with DMCP 3.15 and DM42 3.14, should we use that new combo file now?...I currently have the recent 3.14 combo file installed...
HPMike
Posts: 439
Joined: Fri Jul 21, 2017 11:01 pm
Location: DFW, Texas

Re: What should we do with the new 3.5?

Post by HPMike »

zeno333 wrote:
Sat Jul 27, 2019 3:32 am
It says..."New DMCP+DM42 combo fw only" What does fw only mean?...There is a new combo file with DMCP 3.15 and DM42 3.14, should we use that new combo file now?...I currently have the recent 3.14 combo file installed...
I think "fw" means firmware. There are no software changes. This change is supposed to help improve response to simultaneous key presses. If you haven't experienced any problems in this area, there really is no reason to install it.
DM15L, S/N 00548. DM42, SN: 00159. DM41X, SN: 00973. DM32, SN 00054.
Post Reply