What should we do with the new 3.5?

Discussion around the Swiss Micros DM42 calculator.
Post Reply
zeno333
Posts: 67
Joined: Fri Dec 29, 2017 12:34 am

What should we do with the new 3.5?

Post by zeno333 » Sat Jul 27, 2019 1:32 am

It says..."New DMCP+DM42 combo fw only" What does fw only mean?...There is a new combo file with DMCP 3.15 and DM42 3.14, should we use that new combo file now?...I currently have the recent 3.14 combo file installed...

HPMike
Posts: 88
Joined: Fri Jul 21, 2017 9:01 pm
Location: DFW, Texas

Re: What should we do with the new 3.5?

Post by HPMike » Sat Jul 27, 2019 2:11 am

zeno333 wrote:
Sat Jul 27, 2019 1:32 am
It says..."New DMCP+DM42 combo fw only" What does fw only mean?...There is a new combo file with DMCP 3.15 and DM42 3.14, should we use that new combo file now?...I currently have the recent 3.14 combo file installed...
I think "fw" means firmware. There are no software changes. This change is supposed to help improve response to simultaneous key presses. If you haven't experienced any problems in this area, there really is no reason to install it.
DM15L, S/N 00548. DM42, SN: 00159.

Post Reply