3D printed DM42 stand

Discussion around the Swiss Micros DM42 calculator.
Post Reply
mcc
Posts: 180
Joined: Fri Jun 23, 2017 3:10 am

3D printed DM42 stand

Post by mcc » Fri Aug 24, 2018 5:35 pm

Hi,

just found this (I did not make this myself!)

https://www.thingiverse.com/thing:2826705

all credits goes to the original author of this piece!!!

Cheers!
Meino
DM 42 - SN: 00373, Firmware v.:3.11. / 3.11. as compiled by SwissMicros

Richard Garner
Posts: 2
Joined: Tue May 09, 2017 10:31 pm
Location: Texarkana, AR USA

Re: 3D printed DM42 stand

Post by Richard Garner » Sat Aug 25, 2018 3:19 am

It would be nice if someone could produce an Aztech type case for the DM42. They were perfect for the 42S. When closed they were small and protected the 42S. When open they rested and felt good in the hand and set at the right angle when setting on the desk. They were the perfect case. I would love to have some for the DM42.

wawachief
Posts: 29
Joined: Tue Dec 12, 2017 6:39 pm
Location: France, Normandie

Re: 3D printed DM42 stand

Post by wawachief » Sat Aug 25, 2018 10:22 am

Do you have some pictures of such a case for hp42 ? I don't see what such a case looks like.
DM42 SN:00218
HP-11c - HP-19b - HP25 - HP 45 - HP42s - HP48gx

dlachieze
Posts: 140
Joined: Thu May 04, 2017 10:20 am
Location: France

Re: 3D printed DM42 stand

Post by dlachieze » Sat Aug 25, 2018 10:46 am

Here are some pictures from an old eB auction :

Image Image

Image Image
DM42 SN: 00425

Bill (Smithville NJ)
Posts: 26
Joined: Sat Jul 22, 2017 7:14 pm

Re: 3D printed DM42 stand

Post by Bill (Smithville NJ) » Sat Aug 25, 2018 7:46 pm

The ASTECH case is fantastic. Perfect for protection in the field.

Here's a closeup of the Hinge assembly. There are two pins that hold it together.


Hinge.jpg
Hinge.jpg (202.93 KiB) Viewed 454 times



The case is slightly too wide for the DM42 to fit. I was able to get a nice fit
by cutting two lengths of the soft fabric side of Velcro. Put this on each side
of the case. The DM42 slides in and out nicely and stays in the case.


DM42.jpg
DM42.jpg (210.33 KiB) Viewed 454 times


If you look close, you can see the Velcro on the left and right sides of the case.

Bill
Smithville, NJ

Geoff Quickfall
Posts: 198
Joined: Wed May 24, 2017 8:44 pm
Location: Vancouver Canada
Contact:

Re: 3D printed DM42 stand

Post by Geoff Quickfall » Sun Aug 26, 2018 1:42 am

Another nice thing about the astech is the Ir is still exposed when ope;.

Post Reply