Hi,

ok...it is late and I feel somehow fuzzy...

With our beloved DM42 there are three modes: DEG, RAD and GRAD.

To convert from

DEG to RAD use: use mode DEG and then ->RAD

RAD to DEG use: use mode RAD and then ->DEG

GRAD to DEG use: use mode GRAD and then ->DEG

GRAD to RAD use: use mode RAD and then ->RAD

DEG to GRAD use: use mode DEG and then...pencil and paper

RAD to GRAD use: use mode RAD and then...pencil and paper

"pencil and paper" read as "use your DM42 to calc it by yourself"

Why we are missing to forms of conversions...or do I miss something and

it is really late and me is fuzzy actually?

Cheers!

Meino

## If the RADiation is not strong enough you need some DEGree of GRADitude right now, isn't it?

### If the RADiation is not strong enough you need some DEGree of GRADitude right now, isn't it?

DM 42 - SN: 00373, Firmware v.:3.11. / 3.11. as compiled by SwissMicros

### Re: If the RADiation is not strong enough you need some DEGree of GRADitude right now, isn't it?

No special need for a function since conversion deg <-> grad is done by multiplying with or dividing by 0.9?

DM42 S/N 00761

### Re: If the RADiation is not strong enough you need some DEGree of GRADitude right now, isn't it?

Err... If your DM42 behaves like that it must have a bug...

->RAD and ->DEG convert solely between degrees and radians. ->RAD divides X by 180/π and ->DEG multiplies X by 180/π. See pages 334 and 335 of the HP-42S manual.

->RAD and ->DEG convert solely between degrees and radians. ->RAD divides X by 180/π and ->DEG multiplies X by 180/π. See pages 334 and 335 of the HP-42S manual.

Not SwissMicros staff, just an enthusiast.