[DM41L V27] Shitfing to serial console by itself

If you think you've found a bug in one of these machines, post about it here indicating the steps you perform in order to reproduce it.

Please prefix your topic with the model number in question and firmware version this way:

[DM16 V22] CHS gives unexpected results
Post Reply
michel_b
Posts: 25
Joined: Wed Jan 30, 2019 9:07 pm

[DM41L V27] Shitfing to serial console by itself

Post by michel_b » Thu Feb 07, 2019 9:10 am

Hi,

I saw the following thing happen twice (but at random, not reproducible at will...) on my new DM41L :

- When typing a “C” in [ALPHA] mode, the calculator immediately shifted to [SERIAL CONSOLE] just as if it had been powered up while pressing the [√ x² C] key.

However I don't feel it's a hardware issue at there doesn't seem to be any issue with the [ON] key itself : Otherwise the calculator doesn't go ON/OFF by itself and there doesn't seem to be any malfunction or excessive sensibility of the [ON] key...

But the calculator is not expected to shift to [SERIAL CONSOLE] unless powered up while pressing [√ x² C], so I feel it must be more of a FW bug...

Kind regards.

grsbanks
Posts: 797
Joined: Tue Apr 25, 2017 9:23 am
Location: Preston, Lancs, UK
Contact:

Re: [DM41L V27] Shitfing to serial console by itself

Post by grsbanks » Thu Feb 07, 2019 6:02 pm

This one's new to me. I'm passing it on.
Not SwissMicros staff, just an enthusiast.

Post Reply