Hello,
according to instructions on https://www.swissmicros.com/firmware.php
I've downloaded and installed the drivers, the Update tool and the firmware V27.
Alle steps until "push the "RESET" button" are fine (DM41 displays "SERIAL CONSOLE").
But then the flash progress never is displayed, the Firmware Update Tool stays at
displaying "Press the reset button now ..."
Any hints or recommendation?
Thanks in advance,
Thomas
[solved] [DM41L] Problem updating Firmware to V27
[solved] [DM41L] Problem updating Firmware to V27
Last edited by Thomas_ER on Thu Sep 27, 2018 11:53 am, edited 1 time in total.
[ HP48/49/50/42S/WP34/HP Prime/ DM42 (#00185+00318) ]
Re: [DM41L] Problem updating Firmware to V27
Press the reset button again
It doesn't always work on the first attempt.
It doesn't always work on the first attempt.
There are only 10 kinds of people in the world: those who understand binary and those who do not.
-
- Posts: 795
- Joined: Wed May 03, 2017 7:46 pm
- Location: Malone, NY USA
Re: [DM41L] Problem updating Firmware to V27
I pushed reset until my calculator was blue in the face Finally, I reinstalled the update tool and it went through on the first try.
Tom L
Some people call me inept but I'm as ept as anybody!
DM10L SN: 059/100
DM41X SN: 00023 (Beta)
DM41X SN: 00506 (Shipping)
DM42 SN: 00025 (Beta)
DM42 SN: 00221 (Shipping)
WP43 SN: 00025 (Prototype)
Some people call me inept but I'm as ept as anybody!
DM10L SN: 059/100
DM41X SN: 00023 (Beta)
DM41X SN: 00506 (Shipping)
DM42 SN: 00025 (Beta)
DM42 SN: 00221 (Shipping)
WP43 SN: 00025 (Prototype)
Re: [DM41L] Problem updating Firmware to V27
Hello grsbanks,
many thanks for your answer.
Previously I tried many times, restarting the program, also re-connecting
the calc to the pc, and also re-pressing the Reset Button.
Now I used another USB port (also USB2, no hub (it's my laptop)),
this time with success.
Thanks for your support!
many thanks for your answer.
Previously I tried many times, restarting the program, also re-connecting
the calc to the pc, and also re-pressing the Reset Button.
Now I used another USB port (also USB2, no hub (it's my laptop)),
this time with success.
Thanks for your support!
[ HP48/49/50/42S/WP34/HP Prime/ DM42 (#00185+00318) ]
Re: [solved] [DM41L] Problem updating Firmware to V27
Groan, the Swissmicros site still down, been almost a week,
Please can somebody please past the update instructions and firmware for my DM41L
Regards
Laurence
Please can somebody please past the update instructions and firmware for my DM41L
Regards
Laurence
Re: [solved] [DM41L] Problem updating Firmware to V27
--bob p
DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100
DM42: β00071 & 00282, DM41X: β00071 & 00656, DM10L: 071/100